Thanks milky, just wish had more time to spend finishing it ya know, it's always like...a lil here...a lil there... Slowly but surely. Not lucky enough to have the set up and tools to bang it out!
Thanks milky, just wish had more time to spend finishing it ya know, it's always like...a lil here...a lil there... Slowly but surely. Not lucky enough to have the set up and tools to bang it out!
What size are the roller blade wheels?
72mm 82a
wise, your mill looks very nice, .
but I will add that the cross bar that holds the chain looks a bit to near the end / front of mill, its always best to put a " tack weld " in place on each corner of the tuber steel when your making or doing your first project. a few of my mills the cross bar is near the center, be nice when its finished.
Thanks old timer, I moved it towards the back of my mill for this first one since I like to bait em with the flirt and other stuff sometimes they get wild! My next design has it sitting more towards the middle so I will see what's what but thanks for the feedback always appreciated.
Wise, I'm in the middle of redoing a mill right now. Can you share some details about your main wheels setup? Also, do you mind sharing the cost of you inline skate wheels and bearings (and where you got them)?
Thanks.
Milo
Tri-Star aluminum wheels part # 1183 or #1184. Split wheel that uses a 5/8 bearing. App. $35 a piece.
For the inline wheels or skate wheels the best place is ebay or Amazon. Just scroll thru. You can find sets of 50 wheels for less than a $1 a piece. Discounted/blemished/discontinued. 608 bearings the same.
Best of luck. EWO
Originally Posted by Milo
Thank you very much.
EWO IS RITE ON THE BEARINGS FOR SHORE! I JUST GOT 100 608RS FOR 35 .00 BUT I STILL LIKE MY 10'' RUBBER WHEELS LIKE THE RED RIVER CURLY'S.
Posting Permissions
Reply With Quote